Choosing a solenoid for an OEM assembly usually starts with a constraint, not a part number: available supply voltage, the stroke that has to be delivered, whether the mechanism must hold without continuous power, and the space the coil can occupy. This index collects the engineering guides published by Cixin Industrial and organises them by those constraints so that a design engineer can move from a requirement to the right actuator family.
Each guide describes a product family, the questions that typically decide its suitability, and the installation details that need to be settled before a sample is requested. Where a value depends on a specific winding, duty cycle or mechanical interface, the guide points to the specification sheet rather than quoting a generic figure.
Guides by actuator family and application
Bistable, latching and holding solenoids
Guides for designs that must hold a position without continuous coil power, including bistable latches, holding electromagnets and miniature latch locks.
Open-frame and push-pull linear solenoids
Selection notes for linear actuation in 12 V and 24 V DC systems, covering open-frame construction, push-pull formats and general DC solenoid platforms.
- 12v open frame solenoid
- 24v open frame solenoid
- Open frame solenoid
- 12v push pull solenoid
- 24v push pull solenoid
- Dc solenoid
Tubular, long-stroke and miniature solenoids
Geometry-led guidance for tubular actuators, extended stroke requirements and space-constrained miniature assemblies.
Solenoid valves, pumps and fluid control
Engineering considerations for 2-way and normally-open valves, miniature valve formats and solenoid-driven dosing pumps.
Locks and application engineering
Application-specific notes for door locks, automotive systems, textile machinery and vending mechanisms.
Custom solenoid design and sourcing
How to brief a manufacturer, what information an engineering team needs for a custom actuator, and how to move from a specification to a sample.
From a specification to a sample
When a standard actuator does not fit the envelope, the fastest route is a written brief covering supply voltage, available duty cycle, required stroke and force at that stroke, ambient temperature, mounting constraints and expected lifetime. Our engineering team reviews those inputs against existing platforms before proposing a custom winding or housing. See custom solenoid design with our engineering team, or browse the full solenoid product catalogue.